Skip to content
#1 Source in low voltage wire and cable. Call us today to learn more about special offers.
#1 Source in low voltage wire and cable. Call us today to learn more about special offers.

Gate Mount Pool Alarms - GT10 Series

by GRI
SKU: GT10-4
Various lead times may apply to this product. Please contact us for more details.

These products are all Made to Order

Which means they are non-cancelable and non-refundable


Gate Mount Pool Alarms

The new Gate Mount Pool Alarm was designed as an aid for prevention of an unattended access to a pool/spa area by a small child. Monitoring all gates with closed loop magnetic reed switches, the alarm will sound an alarm should anyone too small to manage the adult pass thru feature attempt access to the pool/spa area. For maximum protection all moveable openings should be protected in such a manner by the alarm.

The GT10-2 and GT10-4 can be operated independently with an on-board 9 volt battery or with a 12 volt externally supplied DC power source. Both power sources have been designed to maintain a maximum sound pressure level of 85db at 10’. Estimated battery life is approximately 180 days based on no alarm soundings during that time lapse. Should the battery voltage drop below 7 volts, a low battery mode will be initiated and the unit will sound 3 beeps approximately every 30 minutes for one to two weeks prior to total battery failure. Battery must be replaced at this time, and the cause of power failure determined and restored.

NOTE: Unit will function at minimum 5VDC at a very limited sounder volume. This power level is considered total battery failure.

CLEANING: Periodic cleaning of sounder and box are required to maintain sound level.

CAUTION: To prevent a memory failure or circuit damage, external power source not to exceed 15 VDC

WARNING: THIS IS NOT A LIFE SAVING DEVICE. Environmental conditions, such as wind, may affect the sound level.



  • Microprocessor Controlled
  • Monitors Entry to Pool and Spa Areas
  • Weather Resistant For Outdoor Use
  • Instant On or 7 Second Delay Models Available
  • Low Battery Indicator
  • Closed Loop 410P Switch Set With 5’ 2-Conductor Cable
  • Made In U.S.A.
  • Color: Grey



Installation Instructions

Installation Instructions

The GATE MOUNT POOL ALARM mounts easily to the fence by any gate which allows access to the pool/spa area. Using a CLOSED LOOP magnetic reed switch, the unit will detect and announce an open access by sounding a loud continuous alarm. Two timed options are offered: A maximum seven (7) second delay mode prior to sounding upon gate opening, or an instant alarm sounding upon activation. Both versions incorporate a built-in pass thru feature shunt button to allow adult access without alarm sounding. Although the GATE MOUNT POOL ALARM cannot be turned off, this feature will simply deactivate the alarm function for a maximum of fifteen (15) seconds. During this time span the adult must exit and close the gate before alarm sounds. Once the alarm is sounding it can not be silenced by simply closing the gate. The shunt button must also be depressed. The sounder cannot be disabled by holding down the shunt button

What's in the Box

What's In The Box

  • 1 x Gate Mount Pool Alarm