Coax Patch Cable, LMR 195 Coax, MIG-195, Low Loss RF, 1' to 100' Reverse, SMA-Male 180 degrees to SMA-Male 180 degrees
Products may look different then pictured
Coax Jumper Cable, MIG-195, 1' to 100' for Radio Frequency Applications
The MIG-195 Coax Patch Cable was designed to deliver high performance with minimal loss. This coax patch cable is LMR®-195 equivalent with a thin, lightweight, and flexible construction. LMR® is a registered trademark of Times Microwave Systems. Our MIG-195 coax patch cord is the perfect high-quality cable alternative to RG-58 and RG-142. The MIG-195 is protected by a durable polyethylene jacket.
MIG-195 coax patch cable applications include wi-fi, antenna cables, ham radio, patch cables, jumper cables, WLL, GPS, WLAN, LMR®, WISP, WiMax, SCADA, and mobile antennas.
Coax Patch Cable, MIG-195, 1' to 100' for Radio Frequency Features
- Connector 1: SMA male
- Connector 2: SMA male
- Cable Type: MIG-195 low loss (LMR®-195 equivalent)
- Polyethylene (PE) jacket
- Antenna cable runs to base stations, Access Points (AP), bridges or CPE
- Cabling between any WiFi or WiMax antenna and the associated equipment
- Indoor or outdoor use
- Land Mobile Radio (LMR®)
- Local MultiPoint Distribution System (LMDS)
- Multi-Channel Multi-Point Distribution Service (MMDS)
- Wireless local loop (WLL)
- Personal Communication Systems (PCS)
- Fixed wireless
- Ham radio
Standard VS Reverse Polarity Types
Reverse polarity type refers to the reverse gender of the interface and contact pin design, not the signal polarity. Coax with reverse polarity type or RP-SMA connector has a center receptacle instead of a male pin. Normal SMA connectors are incompatible with RP-SMA connectors. Coax with RP-SMA connectors are used by Wi-Fi equipment to comply with FCC regulations. These connectors inhibit consumers from breaching airspace with short distance transmissions.